laguna 37 x 2, Owner'S Manual

Page: 72 / 82

Double Drum Sander 37 x 2 72
Lift the conveyor and remove it from the machine by sliding the conveyor out toward the front of the machine. Avoid
tearing the belt on any edges underneath the conveyor bed during removal. Reverse the procedure for re-
installation.
Note: If the conveyor belt continually tracks to one side of the machine, first try reversing the belt on the conveyor
bed. If this does not remedy the problem, place a level on the conveyor bed to make sure the conveyor bed is not
twisted. If it is twisted,
for instructions on squaring up the bed - [ CHECKING MACHINE FOR LEVEL Proper
leveling of the machine is essential to achieve continued maximum performance from the SUPERMAX. Before
making fine adjustments, place the unit where it will be used in the shop. Then adjust the four leveling feet using a
carpenter’s level both across the machine and in line with the machine, placing the level on the conveyor bed. If you
have equipped your SUPERMAX with the caster set, do the same after positioning the machine where it will be
operated most often. Mark the position of the legs on the floor with tape so it can be returned to the same
position.].
If squaring up the bed does not remedy the problem, proceed with the steps below:
Step 1: Check for frays on the edges of the belt as well as any tears or folds. The conveyor belt will not track under
these conditions and a new belt will be required.
Step 2: Check the conveyor drive roller to make sure it is parallel to the bed. Both inboard and outboard sides need
to be even with the bed. The driven roller is a floating mechanism and should be left alone as it needs to be able to
move with the take up brackets when tensioned or loosened for tracking.
REPLACING V-BELT: To change the V-belt on the SUPERMAX, first unplug machine from the outlet. Remove two
screws in lower section of belt guard and loosen the pinch bolt of the motor support casting. Raise the motor and
retighten the pinch bolt. The procedure is the same for single drum sanders except that there is one driven pulley
instead of two.
V-Belt Removal:
1.) Remove the lower outer belt cover by removing the four 10-24 screws holding it in place