laguna 37 x 2, Owner'S Manual

Page: 68 / 82

Double Drum Sander 37 x 2 68
4.) Replace bearings by following Steps 1.) through 4.) under Bearing Replacement (Left Side) below (See Figure
41-44) .
5.) Reinstall V-belt pulleys on the drum shafts, making sure they are in the same position as before. Doublecheck
this alignment after the drums have been bolted back in place, using the measurement from Step 3.) above.
6.) Lower the drums by removing the 2 x 6. Reinstall the 6-Six 3/8" x 1 1/4" bolts in the drum support castings and
tighten them. Install the on/off switch and depth gauge with the 2-two inboard bolts.
Reassembly Procedure:
1.)
Lower the conveyor and spin the drums by hand to make sure the drum shaft is not binding in the bearing. If the
bearings bind, loosen the set screws and the bearing flange for one bearing at a time. Spin the drum within the