19
Vertical adjusting shaft
Vertical adjusting handle
Fitting the side table
1.
Assemble the end table support to the motor.
2.
Fit the end table support shaft ensuring that the flat on the shaft is lined up
with the clamp knob. If the shaft is not clamped on the flat it will damage the shaft
and it will not slide vertically.
3.
Slide the end table onto the support shaft and clamp in position with the bolt.
End table support
End table support shaft
Flat
End table
Fitting the fence
1.
Line up the T nuts with the fence slots.
2.
Clamp the fence with the clamp knobs.
