Laguna Tools MSANWB43X75-2RK-25-0197, Manual

Page: 18 / 43

SANDING PLATEN POSITION SANDING BELT OSCILLATION SPEED
( FOR THE ROLLER WITH PLATEN ONLY) The sanding belt oscillation is controlled by the air cylinder.
The sanding platen is constructed of graphite cloth and felt. Oscillation speed can be adjusted by means of the speed controller on the
It is applied for polishing or fine finishing operations with about 0.1mm cylinder, see Figure 10.
sanding load. But it is not suitable for neavy sanding operations.
Positioning of the platen depends upon the type of wood being used. Loosen the fixing nut on the speed controller, then turn controller
Adjust the platen position with the platen adjustment knob, see Figure 9 clockwise to decrease oscillation speed. Turn counter-clockwise to increase
Turn it clockwise to lower the platen, counter-clockwise to raise it. Each oscillation speed.
revolution of the knob is 0.2mm. The hole in the air eye should be checked frequently. If it becomes
blocked with dust, it may casue the sanding belts to run out of its normal
track and the mahcine will shut off. In the event of blackage, this hole
should be cleaned.
THE PLATEN SHOULD ALWAYS BE KEPT CLEAN.
AFTER SANDING IF THE WORKPIECE HAS STRAIGHT NOTCHES
ACROSS IT, THE GRAPHITE CLOTH AND FELT HAVE WORN
OUT AND SHOULD BE REPLACE IMMEDIATELY.
Figure 9
Figure 10
13
NOTICE !!