Laguna Tools MPL1301-0130, Manual

Page: 19 / 32

19
3. Loosen the guide and move to align the job with the cutter head and clamp.
4. Bring the other guide up against the job and clamp in position.
5. Check that the job moves freely without excessive clearance.
Test Run.
Now that the assembly is
complete, it is time to conduct a
test run.
During the test run, you will check
the following points.
1. Motor starts and runs smoothly.
2. The stop button functions
correctly.
Before you run the machine,
check the following.
1.
All the tools have been removed
from the machine.
2. All the guards are in place.
3. You are wearing the appropriate
safety equipment.
4 . You have read and understood the instruction manual.
Note. If any of the below functions fail to operate correctly, the fault must be
corrected prior to continuing to the next test. Any investigation to find or correct a
fault must be conducted with the power disconnected.
Note. The stop button, when pressed in, with remain in the off position until reset.
To reset the stop button, unlatch the cover. Check that the cover is unlatched prior
to conducting the below tests.
1. Put the gear box handle in the neutral position.
Note. Never start the machine with the gearbox engaged.
2. Start the machine by pressing the green start button.
The machine should run smoothly with little or no vibration.
3. Press the red stop button. The machine should slow down and stop.
Adjustments.
Note.
The machine has had all its functions calibrated at the factory, but due to
shipping conditions, some movement may have taken place. This is unavoidable,
and it is therefore recommended that the following checks are made prior to starting
production. As the machine is used, some functions may move, and it is good
practice to know the process for adjusting the machine prior to production.
Start / stop button
closed
Start / stop buttons