Part# VDL-18
35
REV#082020
2. For tilting the table to left (max. -6º), the table has a reference stop bolt that is used to
quickly align the table after tilting. The stop bolt hits the tilt-blanking disc when it is
positioned over the table tilt hole. When the tilt blanking disc is moved away from the hole,
it allows the tilt stop bolt to pass through the table tilt hole, and the table can be moved to
the maximum amount of tilt (-6 degrees).
Tilt stop bolt Tilt blanking disk
Tilt blanking disc
Table tilt hole
Fence Assembly Adjustment:
-
The following steps are to properly adjust the Fence Assembly Adjustment on the VDL-18
Bandsaw. This will change the accuracy length cut of the workpiece. Check the clearance
between the table and the fence. The fence should not rub against the table surface but be
slightly above it. This gap should be the same at the front of the table as it is at the rear.
1. Loosen the fence locking wheel located on the fence assembly.
2. The fence is now free to move vertically along the worktable.
3. Once in the desired spot, lock the fence in place by tightening the locking screw.
Maintenance
Before performing any maintenance to the machine, make sure to unplug the cord from
the power source before cleaning.
-
Maintain bearing guides clean and free of build-up.
-
Check that the cleaning brush over the band wheel is working properly and remove any
deposits from the band wheels to avoid vibration and blade breakage.
-
The table surface should be always kept clean and free of rust for best results. talcum powder
applied with a blackboard eraser rubbed in vigorously once a week; this will fill casting pores
and form a moisture barrier. This method provides a tabletop that is slick and allows rust rings
to be easily wiped from the surface.
Summary of Contents for Dake VDL-18
Page 38: ...Part VDL 18 38 REV 082020 Parts List Upper Wheel Assembly Parts List Below...
Page 42: ...Part VDL 18 42 REV 082020 Table and Fence Assembly Parts List Below...
Page 46: ...Part VDL 18 46 REV 082020 Upper Lower Blade Guides Assembly Parts List Below...
Page 58: ...Part VDL 18 58 REV 082020 VDL 18 Wiring Diagram...