17
7. Remove the bezel on the other side. Check that the number
of the sticker at the back of the bezel matches the number
placed on the computer
8. Remove the adhesives protections
9. paintTROTTER is ready to work
6. Place the trim on the other side. Check that the numerical
adhesive on the back of the trim matches the number pla-
ced on your machine. Screw the trim on the front and the
top side. Place first curtain A (impulsion) and then curtain B
(aspiration).
Check the numeric adhesive on the back of the sheet mat-
ches the number placed on your machine. Unroll the curtain
completely and screw the plate on the front and top side.
Remove the adhesives protections.
It is placed as follows:
1. The tube is placed on the surface of the ceiling of the pain-
tTROTTER.
2.
One end of the tube is fixed to the extraction inlet by means
of the clamping flange and tightened firmly.
3.
Fix the tube with the cable added to the packaging and fix
it to the plenum box of the paintTROTTER Evo as shown in
the following illustrations.
4.
The other end of the tube will be fixed to the outlet flange
by means of the clamp and the two hooks integrated in the
flange itself, as shown in the picture. The outlet to the out
-
side depends on where it is installed.
The extraction duct is placed over the paintTROTTER, as shown
in the following picture:
- EXTRACTION DUCT FIXATION
