FLIP
®
01.01.2019
English / Englisch
7.2 TIGHTENING THE V-BELT
ATTENTION!
Do not overtighten the V-belt! This will allow you to avoid
excessive wearing of the V-belt and the pulleys!
The V-belt must be retightened from time to time. To do so, proceed
as follows:
1
Switch off the machine and pull the power plug out of the
socket!
2
Lay the machine on its side or with the motor housing on a
table. Avoid damages to the floor or table and the machine.
3
Use the universal spanner to undo the two screws which
connect the attachment to the fan housing (fig. 35).
4
Use the universal spanner to undo the screw which attaches
the belt tightening plate (fig. 36).
5
Hold the FLIP
®
by the fan housing and press the belt tightening
plate forward towards the attachment at the same time with
your thumb (fig. 37, 1).
Use your other hand and the universal spanner to retighten
the three screws (fig. 37, 2 and 3).
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
Fig. 37
Hold the FLIP
®
by the fan housing, press on the
belt tightening plate (1) and retighten the three
screws (2 and 3).
Fig. 35
Undo the two screws that connect the attachment.
Fig. 36
Undo the screw which attaches the belt tightening
plate.
7
30