ELF 01.10.2019
English / Englisch
WORKING WITH THE ELF
5.2.2 CENTRIFUGAL SANDING DRUM
If the machine is fitted with a centrifugal sanding drum, proceed
as follows:
1
Lift the sanding drum off the floor by turning the lowering
lever at the handle upwards (fig. 36).
2
Switch off the machine and pull the power plug out of the
socket!
3
Swing the drum cover upwards on the front of the machine
housing (fig. 37).
4
Pull the worn sanding sleeve off the sanding drum (fig. 38).
5
Push the sanding sleeve as far as necessary over the sanding
drum until the abrasive projects equally at both sides of the
sanding drum (fig. 39).
6
Close the housing opening by swinging the drum cover back
downwards.
Make sure you feel the cover lock into place
(fig. 40)!
7
Connect the machine to the mains supply (
Section 4.2,
Connecting the power cable
).
CAUTION!
RISK OF INJURY and RISK OF PROPERTY DAMAGE from
rotating parts of the machine:
• Always ensure that the sanding sleeve is correctly
positioned before switching on the machine!
• Always lift the sanding drum off the floor before switch
on the machine (fig. 36)!
8
It is now possible to execute the next sanding step with the
machine.
5
Fig. 39
Push the sanding sleeve over the sanding drum
until the abrasive projects equally at both sides
of the sanding drum.
Fig. 40
Swing the drum cover back down to close it.
Make
sure you feel it lock into place!
Fig. 37
Pull the power plug out of the socket
and swing
the drum cover upwards.
Fig. 38
Pull the worn sanding sleeve off the sanding drum.
29
Summary of Contents for ELF
Page 1: ......
