ELF 01.10.2019
English / Englisch
WORKING WITH THE ELF
•
After replacing the abrasive, start working in poorly lit areas
of the room in order to remove the initial aggressiveness of
the abrasive.
5.2 CHANGING THE ABRASIVE
Depending on the type of sanding process you wish to perform,
different abrasive grits can be selected.
5.2.1 SANDING DRUM FOR CLAMPING ABRASIVE PAPER
If the machine is equipped with a sanding drum for clamping abra-
sive paper, proceed as follows:
1
Lift the sanding drum off the floor by turning the lowering
lever at the handle upwards (fig. 26).
2
Switch off the machine and pull the power plug out of the
socket!
3
Place the paper template on the reverse of the unrolled
abrasive sheet. Use a carpet knife to cut the abrasive sheet
according to the template (fig. 27).
4
Tilt the machine backwards over the safety guards (fig. 28)
and place it down carefully on the floor (fig. 29).
Ensure that
the machine is standing securely!
5
Fig. 26
Lift the sanding drum off the floor by turning the
lowering lever at the handle upwards.
Fig. 27
Use a carpet knife to cut out the abrasive sheet
around the template.
Fig. 28
Pull the power plug out of the socket
and tilt the
machine backwards over the safety guards.
Fig. 29
Place the machine carefully on the floor.
Ensure
that the machine is standing securely!
26
Summary of Contents for ELF
Page 1: ......
