USER’S MANUAL
Double-circuit hob (Ring B, 1000/ 2100 W) :
Set the heating power controller to position 10 then, when the elements is red-
hot, reduce the heat to the position required for cooking.
To obtain maximum power from the double element, set the knob to the MAX
position.
Bring the knob back to a position between 1 and 10 to regulate the overall
temperature of the hob.
To switch the additional circuit off
0
.
Recommendations
Use pots having a slightly concave smooth base in order to avoid scratching the hotplate.
Make sure the size of the utensil is appropriate for your requirements. The diameter of the utensil
base must be he same or slightly greater than that of the screen printing on the hotplate.
Never place or leave an empty enamelled or aluminium utensil on a heat source. Similarly, do not
place products wrapped in aluminium foil directly on the hob as this can cause permanent damage
to your appliance.
Avoid spilling sugar or syrup splashes, remove them immediately because they can cause small
chip marks.
Never apply more heat than can be absorbed by the food: too much heat causes loss of water,
grease and wastes energy.
Whenever the recipe permits, cover your pans with pids in order to save energy.
Remember to return the control knob to O shortly before the end of cooking because the accumulated
heat will complete the cooking.
CAUTION :
If any surface crack appears, immediately insolate the appliance from the mains and
contact your installer.
-!8
RADIANT ELECTRIC HOB
Cormatin - Ft 120a - GB - Rév 07 - Modifié le : 07/10/2013 33/44