Labrie automizer, Operator'S Manual

Page: 55 / 74

50 Operating the A
UTOMIZER
TM
R
ECYCLER
2.
Check the emergency red button.
3.
Press the yellow button to ensure the packer is completely retracted.
4.
Check around the packer for any obstruction preventing it from moving freely.
5.
Check fuses and breakers in the console.
6.
Report your findings to the maintenance personnel.
Emergency Actions
Hydraulic Oil Spill
In case of hydraulic spill, do the following:
1.
Press the emergency red button.
2.
Turn off the pump switch and stop the truck engine.
3.
Close the main valve on the hydraulic tank.
4.
Carefully inspect and find the cause of the leak.
5.
Call the maintenance facility and report your findings.
6.
If the leak can be repaired on site, and the vehicle cannot be towed, remove the pump drive shaft
before restarting the engine.
7.
When it is time to restart the pump, ensure that the valve on the hydraulic tank is fully open and
that there is sufficient oil in the hydraulic tank.
Someone is Trapped in Packer System
In such a case, do the following:
1.
Hit the emergency stop button (red).
2.
Call for help and then proceed with first aid.
Pack on the Go
It may be useful to expedite the collection process and be more efficient. The A
UTOMIZER
TM
R
ECYCLER
gives you the possibility to pack on the go or allow the packer to cycle while you drive.
As you are finished loading the hopper, you can activate the multi-cycle switch and press the start
cycle button (green). This will allow the packer to cycle, even if you are moving the vehicle to the next
pick up. When moving the vehicle, the hydraulic pump will turn at engine RPM, which depends on
truck speed.
The multi-cycle function allows the packer to perform up to eight (8) cycles when pressing the start
cycle button (green). Standard factory preset of the module is three (3) cycles.