ATTENTION!
During
assembly it is necessary to place the blind in the window when it is lifted up; mark the position of the screws on the
window wing, fit the blind and then lower it. Each manipulation of the blind before assembly (if necessary) is only to be
performed in the horizontal position
Any other manipulation is forbidden and claims for such damaged blinds will not be
accepted!
ATTENTION!
Pursuant to the EN 13120:2014 standard, window blinds shall be installed in accordance with the
following instructions:
Chain:
If abreakaway coupleris used:
The chain length must be limited as follows:
1)
If installation height (H0) is not specified, the chain length (H2) shall be less than or equal to 2/3 of the blindheight
(see Fig.): H2
≤
2/3 H.
2)
If installation height (H0) is specified, the distance from the floor to the bottom part of the pull cord (H1) shall be at
least 0.6 m: H1 >0.6 m.
A dangerous loop must be eliminated when a mass of 6 kg is applied or within 5 seconds of application.
APPLY ONE HALF OF THE COUPLER TO EACH END OF THE CHAIN AND THEN LOCK BOTH COUPLER HALVES.
Summary of Contents for HIT
Page 3: ...ILLUSTRATIVE ASSEMBLY...
