1.4 Accessories supplied with centrifuge
- One 6 x 15mL rotor
- Six rubber cushions
Additional accessories available:
-
Combination adapters for 5mL and 7mL tubes, (6pk)
1.5 Warranty
This centrifuge has been subject to thorough testing and quality control. In the unlikely
event of a manufacturing fault occurring, our one year warranty (from the date of
delivery) covers the centrifuge and the rotor. This warranty becomes invalid in the case
of incorrect operation, use of nonstandard spare parts or accessories and unauthorized
modification of the rotor or centrifuge.
Labnet reserves the right to make technical modifications. Statements contained herein
are not to be considered binding.
2. Installation
2.1 Unpacking the centrifuge
The centrifuge is delivered in a carton with two or more formed foam blocks. Please
retain the carton and the blocks until it has been established that your unit is working
properly.
The accessories supplied with the centrifuge should be kept with the instruction manual
near the centrifuge’s place of installation.
2.2 Required space
The centrifuge should be installed on a rigid, even surface such as a stable laboratory
bench, cabinet, etc. To guarantee sufficient ventilation, ensure that the centrifuge has
at least 15cm (6 inches) of free space on all sides, including the rear.
The centrifuge should not be located in areas subject to excessive heat such as in direct
sunlight or near radiators or the exhaust of a compressor, as a buildup of heat may
occur within the centrifuge bowl.
2.3 Cushion Installation
Before inserting any tubes into the centrifuge the rubber cushions must first be properly
installed. To install the cushions turn a 10 or 15mL round bottom tube upside down and
place the cushion on top. Then remove the rotor shield and place it on top of the tube
while pushing the cushion into the end of the shield. Then reinsert the shield.
