2 | AccuBlock Digital Dry Bath
3.1 Unpacking
3.0 Getting Started
Upon unpacking the Dry Bath, inspect for damages. Shipping damage is the responsibility of the carrier.
Open the
AccuBlock Dry Bath
package and confirm that all items are included:
•
Dry Bath unit
•
Block Lifter
•
Data logger software
•
Lid
•
Line cord
•
USB cable
If there are any items missing, damaged, or not according to your order, please contact your distributor or
sales representative immediately.
3.2 Initial Operation
Select a location that is dry and not subject to drafts or moving air from heating or air conditioning
vents, or air blown by other equipment. Place the unit on a flat, preferably non-flammable surface. Allow
sufficient room around the unit for access and cooling. Six inches minimum on all sides is suggested.
Plug the unit into a properly grounded outlet. Using the lifter, insert the block(s) into the well. The unit is
now ready for use.
4.0 Controls
•
On/Off rocker switch. Located on back of unit. Turns primary power on and off
•
“Start/Stop” LED, red. Used to activate or stop the unit. Illuminates when unit is in heating mode, off in
temperature set mode
•
“Heating” LED, red. Illuminates when unit is in heating mode and unit is actually apply heat to the block.
This LED is on continuously during heat-up and cycles and off when the unit is at set temperature.
•
“Time” LED, green - Used to set or select time mode. This LED light indicates running Time Mode.
•
“TEMP-UP arrow key. Raises set temperature when unit is in set mode.
•
“TEMP-DOWN” arrow key. Lowers set temperature when unit is in set mode
•
“Timer-UP” arrow key. Raises set time when unit is in set mode.
•
“Timer-DOWN” arrow key. Lowers set-time when unit is in set mode.
•
To enter continous mode, set the time to 00:00, hold the “Timer-DOWN” arrow key while pressing the
“Start/Stop” key. Unit will display “Hold”.
4.1 Keypad Function
Summary of Contents for Accublock D1301
Page 11: ...AccuBlock Digital Dry Bath 7...
