9
4.2.2) PASSWORD
To prevent the door work program from being modified, it is possible to set a password that must be entered every time the programmer
ET‑DSEL is used.
To enable the password, perform the operations listed below:
1. Press the SET button for 5 seconds to access the general programming menu (see Diagram 1 at para. 4.2.1)
2. Press the button F1 five times to go to the Password Management sub-menu.
3. Press the Enter button
to access the “Password management” section.
PASSWORD MANAGEMENT
This section displays the two passwords available to the final user, the primary password and the service password.
The technical password is only reserved for the technical staff in charge of installation and maintenance operations.
PRIMARY PASSWORD (for the system owner-user)
It is a 5‑character password used by the user to prevent unauthorized persons from having access to the programmer ET‑DSEL and
changing the work program.
Using a primary password is optional and must be enabled by system owner.
The default technical password is “A‑A‑A‑A‑A”.
WARNING!
When enabling the password, be very careful not to forget the access combination.
SERVICE PASSWORD (for user)
It is a 5‑character password that the system owner may provide to persons authorized to use the programmer ET‑DSEL.
With the service password, it is only possible to change the work program of the automatic door.
The default service password is “A‑A‑A‑A‑A”.
To change the service password, it is necessary to log in using the primary password.
Use the button
to move the selection arrow downwards, use the F2 button to move the arrow upwards.
HOW TO CHANGE THE PRIMARY PASSWORD
•
Select “PRIMARY PASSWORD”
•
Press OK (F1).
•
Enter the new primary password, selecting a combination of 5 characters from the letters
A‑B‑C‑D.
•
Enter the default primary password “A‑A‑A‑A‑A” pressing 5 times the button A.
(If the primary password is not the default password, since it had already been changed
before, enter the currently‑used primary password).
