Labconco SteamScrubber 4010010 Series, User Manual, Page: 41 / 108

41
Start Program
Touch the Start Program Icon (Fig. 6-2). A pop-up confirmation will display, which will
show the selected program, the data acquisition rate, the printer format, and any
programed time delay. Time delay settings can be modified from this screen by
touching the time and selecting a new delay time. If all settings are correct press
[OK]
to begin the program. Once the program begins, the Home Screen will change as
shown in Fig. 6-3. The system temperature is displayed next to the current running
program and the total estimated time remaining to complete the program is displayed.
Program Progress
The Program Progress Indicator graphically displays the progress of each segment of
the program as the washer progresses through the cycle. Once a segment is complete,
a blue check mark is shown. If a non-fatal alarm occurred during the segment, a yellow
check mark is displayed. If the program is canceled or any fatal alarm occurred
(automatically ends the cycle) a red
X will be displayed. A single touch to the Active
Segment will display the current segment step and time remaining of that step within the
running segment i.e. Fill/Heating/Wash/Drain. The step information will be displayed for
10 seconds, or until the Active Segment is touched again.
SYSTEM
TEMPERATURE
CYCLE TIME
REMAINING
CANCEL
PAUSE
CHART
PROGRAM
PROGRESS
INDICATOR
CURRENT
PROGRAM
PROGRAM
SEGMENT
COMPLETED
SEGMENT
ACTIVE
SEGMENT
Figure 6-3