Labconco 44000 Series, User Manual

Page: 49 / 107

Chapter 4: Using Your Washer
45 P#o%&ct Se#+ice -./00.122.341/
The detergent dispenser opens during the second wash
cycle, except when the Plastic cycle is selected, which has
only one wash cycle. If your glassware is heavily soiled,
you may want to add powder detergent to the pre-wash
cavity. Do not use liquid detergent in the pre-wash cavity
in the washer door. The initial drain and fill cycle will
flush the liquid detergent out of the washer prior to the
first wash. Refer to the table below to determine which
cavities to fill, based on the selected wash choice. You
may use either the pre-wash cavity stamped in the washer
door or the one on the lid of the detergent cup.
Wash Cycle Fill Pre-wash Cavity Fill Main Cavity
Rinse Only NO NO
Plastic NO YES
5lass OPTIONAL YES
5lass Plus OPTIONAL YES
Scientific OPTIONAL YES
User 1 OPTIONAL YES
User 2 OPTIONAL YES
Do not use combustible solvents in the
Glassware Washer. If soiled glassware
contains flammable compounds, rinse the
glassware thoroughly prior to placing the
glassware into the washer. Heaters in
the washer are very hot and could cause
a fire.
ALWAYS RINSE 5LASSWARE
THOROU5HLY BEFORE PLACIN5
THE 5LASSWARE INTO THE
WASHER. PETROLEUM BASED
COMPOUNDS MAY DE5RADE
CERTAIN INTERNAL WASHER
COMPONENTS.
Non-foaming powder or liquid detergent formulated for
labware washers, in conjunction with adequate hot water,
is vital for obtaining clean glassware. If the water is soft,
less detergent may be needed. Too much detergent with
softened water may cause etching of the glassware. This
appears as a permanent cloudy film on the glassware.
To achieve the best
results with your
Glassware Washer, use
Labconco’s LabSolutions
Detergent.
!
☞