Installation_Sliding gate_Rack and pinion_N°7401
This document is the exclusive property of FTFM La Toulousaine and must on no account be copied. It may be modified at any time in accordance with product changes.
09/15
p.4
9
-
Using the drill make 2 marks, then remove the stop and drill the rack and pinion with a
Ø5 mm drill bit.
-
After drilling the hole, replace the stop and fix it to the rack and pinion with 2 sheet
metal screws TF Ø5,5 mm x 45 mm.
10
-
Place the gate in the open position, then close it 2 cm from the post.
Place the stop on the rack and pinion in front and press the limit switch sensor.
2 cm
Position of the limit
-
switch stop
OK
No
11
-
Repeat step 9 to set the limit
-
switch stop.
12
-
Re
-
engage the operator (Refer to the operator manual).
External view.
The gate overhangs the opening by 2 cm.
Be
hind
In
front
o
f
