27
Engli
S
h
Note: The filter is inserted inside the cup pressure , to remove enough force on the sides and then pull it out .
Do not remove the snap ring inside the filter holder
3) Clean the brush supplied with the group’s headquarters where you insert the filter holder .
4) Place the cup in the group and press the button completely without docking continuous delivery .
5 ) Allow to drain the water to overflow from the filter holder (in this way you clean the dispensing group ) .
The continuous flow of water from the unit can cause burns due to accidental skin contacts.
6 ) Stop the water supply and lock the bowl in the group.
7) Start the continuous delivery and then stop after a couple of seconds and repeat this a few times (so that
you clean the drain channel and the solenoid valve of the dispensing unit ) .
8) Clean the filter drilled and put it back in the cup . Supply water for a couple of seconds to clean the filter
, the cup spouts .
9) Repeat the same operation on all groups dispensing.
Note: Special commercially available detergents can be used to effectively clean the serving units.
7.2 Cleaning the tray and the cup support grill
The lower cup support grill 5 must be kept clean at all times; during the normal use of the machine, it is suf-
ficient to clean it with a sponge or a moist cloth. At the end of the working day, clean the tray and the grill also
in the internal areas using warm water and neutral detergent.
7.3 Cleaning the steam spout
Clean the steam spout with a sponge or a moist cloth at the end of the working day to remove all traces of milk or other
substances that inevitably form during the normal operation of the machine. Open the steam tap, placing the spout in
the tub, to remove any residues which may have accumulated in the spout.
7.4 Substitution of boiler water
To change the water inside the boiler, proceed as follows:
1) Cut off the power supply to the machine by turning the main switch 1 to position 0 (zero).
2) Remove the tub and the cup support grille and open the boiler drain tap.
3) Open a steam drawing valve to facilitate the draining of the water until the end of the operation.
4) When water no longer comes out of the boiler, close the boiler drain and the steam drawing tap.
5) Charge the machine with water following the instructions of paragraph “Charging the water in the boiler”.
6) To improve product quality, it is recommended to replace the water in the boiler and to change the water
contained in the water circulation pipes when starting the machine every day.
8. idle periods
If the machine is to remain idle for long periods (weekly closing days, holidays, etc.), take the following precautions:
1) Turn the main switch to 0 (zero) and as necessary disconnect the power cord or the main switch of the
electrical mains.
2) Close the cut-off valve of the water mains.
3) If you think the temperature might drop below 5 °C, completely drain the water system of the machine.
4) Wash the components of the machine as described in the paragraph on routine maintenance.
5) Cover the machine if necessary.
