41
English
• Do not use harsh or harmful detergents such as alcohol, petrol or solvents to clean the
coffee machine; use water and neutral detergents.
Note:
The daily cleaning operations must be carried out in order to maintain the efficiency of the machine and to
guarantee the safety of the user and of the persons around it.
8.1 Cleaning the serving units and the filter holder
1) To clean the dispensing unit use the filter-cup with blind filter supplied.
Nota: For cleaning of the dispensing unit use only the cup with blind filter supplied.
2) With the brush supplied clean the dispensing unit where you insert the filter cup.
3) Place the cup in the dispensing unit, don’t locking completely, press the continuous button for dispensing.
4) Allow to drain the water from the filter-cup (in this way you clean the dispensing unit).
The continuous flow of water from the unit can cause burns due to accidental skin contacts.
5) Stop the dispensing of water and lock the filter-cup on the dispensing unit.
6) Start the continuous dispensing of coffee and after a couple of seconds press the button again to stop.
Repeat this a few times (so that you clean the drain channel and the solenoid valve of the dispensing unit).
7) Remove the blind filter-cup from the dispensing unit.
8) Repeat the same operation on all dispensing unit.
9) Clean the filter drilled and put it back in the filter-cup. Dispensing water for a couple of seconds to clean
the filter and the cup spouts.
Note: Special commercially available detergents can be used to effectively clean the serving units.
8.2 Cleaning the tray and the cup support grill
The lower cup support grill
5
must be kept clean at all times; during the normal use of the machine, it is suffi-
cient to clean it with a sponge or a moist cloth. At the end of the working day, clean the tray and the grill also
in the internal areas using warm water and neutral detergent.
8.3 Cleaning the steam spout
Clean the steam spout with a sponge or a moist cloth at the end of the working day to remove all traces of milk or other
substances that inevitably form during the normal operation of the machine. Open the steam tap, placing the spout in
the tub, to remove any residues which may have accumulated in the spout.
8.4 Substitution of boiler water
To change the water inside the boiler, proceed as follows:
1) Cut off the power supply to the machine by turning the main switch
1
to position
0
(zero).
2) Remove the tub and the cup support grille and open the boiler drain tap.
3) Open a steam drawing valve to facilitate the draining of the water until the end of the operation.
4) When water no longer comes out of the boiler, close the boiler drain and the steam drawing tap.
5) Charge the machine with water following the instructions of paragraph “Charging the water in the boiler”
6) To improve product quality, it is recommended to replace the water in the boiler and to change the water
contained in the water circulation pipes when starting the machine every day.
