23
EN
Place the cups under the spouts and start to
dispense coffee using the group head control
lever (
17
).
Once the required amount of coffee has been
dispensed, stop delivery using the group head
control (
17
) and leave the filter-holder in place.
To prepare additional cups of coffee, remove the
filter holder (
22
) from the group head by moving
it towards the left, empty the coffee grounds into
the drawer and repeat the steps described above.
Do not touch the group heads or the
steam and hot water nozzles when the
machine is in operation and do not place
your hands under the groups or nozzles
during delivery in order to avoid possible
scalding.
It is recommended to leave the filter holders,
together with the filters and coffee grounds, in the
group head so that the filter holder will always be
at the right temperature.
When the machine is new, the filter
holder may not be aligned (perpendicular
to the machine) as shown in the figure.
However, this however does not prevent
the machine from working properly.
After being used for a short time, the filter
holder will gradually become settled in
the correct position.
(
Fig. 4
)
A. Position of the closed filter holder when the
machine is new.
B. Position of the closed filter holder after the
machine has been in use for a short time.
7. DISPENSING COFFEE
7–1. MODEL DESIDERIO "V"
Espresso coffee machine with electronic dosing
and temperature control for each group head and
boiler using PID temperature control technology.
Touch screen display for the dispensing controls
with four programmable coffee settings, timed
hot water dispensing.
Timer display for displaying the temperature of
the group heads and coffee dispensing times.
Reinforced steel illuminated buttons for
dispensing coffee and hot water.
7–2. MODEL GENIALE "V"
Espresso coffee machine with electronic dosing
and PID technology boiler temperature control.
Timer display for displaying the temperature of
the boiler and coffee dispensing times.
Reinforced steel buttons for controlling delivery,
with four programmable coffee settings, timed
hot water dispensing.
7–3. MODEL GENIALE "M"
Espresso coffee machine with semi-automatic
continuous delivery group heads with solenoid
valve.
Coffee is dispensed by pressing the illuminated
switch (
17
).
The switch will start the electric pump to deliver
water under pressure and a solenoid valve to
open the group head to allow the heated water to
wet the coffee to pre-infuse and then infuse it.
Once the required amount of coffee has been
obtained, press the illuminated switch again to
stop delivery.
8. TOUCH SCREEN DISPLAY
PROGRAMMING INSTRUCTIONS (MODEL
"DESIDERIO V” ONLY)
Programming can be carried out using the touch
screen display (
5
).
The figure below shows the 8 tactile zones with
which you can interact and move around the
various menus on the display.
8–1. IDLE-OFF DISPLAY (Fig. 5)
The touch screen display (
5
) in IDLE-OFF mode
appears as follows:
A - access TECHNICAL PROGRAMMING
B - switch on machine
tactile areas
tactile areas
Summary of Contents for desiderio 3v
Page 2: ...A B C D E F G DESIDERIO V GENIALE V GENIALE M 2 3 4 A B 1...
Page 3: ...A B C D E F G DESIDERIO V GENIALE V GENIALE M 2 3 4 A B 1...
Page 5: ......
Page 6: ......