La Pavoni DAYTONA 1-POWER, Technical Instructions

Page: 31 / 82

383033GB Pag. 31 November 2003
SMART CARD CREDIT CHARGE PROCEDURE
This procedure is enabled only for the following machine configurations: self with credit card, self with credit card + coin
mechanism.
To enter the credit charge environment, proceed as follows:
Turn the machine in ON mode
Insert the owner or technician’s smart card into the proper slit.
Press the key N°16 (3.4.5…X), the display shows:
SYSTEM PROGRAMMING
CREDIT CHARGE
Press the key N°16 (3.4.5…X) to confirm entering the environment.
The display shows:
SYSTEM PROGRAMMING
CREDIT CHARGE
INSERT SMART CARD
Remove the technician or owner’s card, and insert the card where you want to programme the credit.
Once the card to be programmed has been inserted, the display will automatically show the machine device code:
SYSTEM PROGRAMMING
CARD CODE
X XXXX
Insert the code relevant to the card to be programmed.
To insert the card code, proceed as follows:
The blinking
X number indicates the first figure of the code to be modified:
Press the key N°13 (1x) or N°14 (2x) to modify the figure.
Press the key N°16 (3.4.5…X) to confirm the modification.
Press the key N°15 (gost2) to enter the next level without saving the modification carried out.
Press the key N° 12 (gost1) to return to the previous environment and/or exit.
After having modified the first figure and confirmed the operation, the display shows:
SYSTEM PROGRAMMING
CARD CODE
X X XXX
Where the blinking
X number indicates the second figure to be modified, etc. etc.
Repeat the above operations for all the other figures.
Once the card code has been entered, the display shows:
a)
SYSTEM PROGRAMMING
CREDIT CHARGE
CURRENT CREDIT XXXXXXX
ADD YYYYYYY
Where:
XXXXXXX
indicates the residual card credit
YYYYYYY indicates the value that can be added to the card
Press the key N°13 (1x) or N°14 (2x) to modify the value to be credited.
Press the key N°16 (3.4.5…X) to confirm the modification.
Press the key N°15 (gost2) to enter the next level without saving the modification carried out.
Press the key N° 12 (gost1) to return to the previous environment and/or exit.
The display shows:
SYSTEM PROGRAMMING
CARD CODE
FUCNTION OVER