La Monferrina G2, User And Maintenance Manual

Page: 36 / 58

Maintenance IMPERIA & MONFERRINA S.p.A.
32 G2
GB
General information
This section describes the inspection and routine maintenance operations
that are indispensable to ensure correct functioning of the machine.
Any other intervention required to correct failures or operative anomalies
are to be specifically authorised by the manufacturer.
In such cases always indicate the identification data (model, serial
number, identification of electrical, pneumatic systems etc.).
For important repairs it is advised to contact the manufacturer who, by
means of the specialised technicians with all the technological experience
of the original construction in the plant, can always offer advice and
promptly intervene.
For the maintenance or replacement of commercial components installed
on the machine, follow the instructions supplied directly from the
Manufacturers and contained in their specific handbooks or catalogues.
General safety rules
Maintenance work is to be carried out by skilled technicians who have
been trained in the specific sectors that for this machine are:
•
Mechanical maintenance
•
Electrical systems maintenance
It is the specific task of the Safety Officer to ensure the professional
qualifications and capability of these persons.
Before starting a maintenance operation, the safety officer shall::
•
Free the area of materials and persons not involved in the work in the
area.
•
Make sure that the equipment required is available for the
maintenance engineer and that it is in good condition.
•
Check there is sufficient lighting and if necessary provide portable 24
Volt lamps.
•
Make sure that the maintenance engineer is equipped with the
relevant personal protection devices needed for the specific job
(gloves, goggles, shoes, etc.).
•
Make sure that the maintenance engineer has carefully read the
instructions contained in this handbook and is familiar with the
machine functioning.
Before starting the relevant job, the maintenance engineer shall:
•
Cut-out all power supplies (electrical, hydraulic, pneumatic) and block
the machine in safety condition.