La Marzocco USA
| 1553 NW Ballard Way — Seattle, WA 98107
T. 206.706.9104 | F. 206.706.9106 | [email protected] | www.lamarzoccousa.com
1.
Turn off and unplug the grinder.
2.
Close hopper gate and remove hopper. Scoop as
many whole beans out of the grinder inlet and
place them in hopper.
3.
Remove the four screw caps using your fingernail
or a spudger.
4.
Remove the four screws using a 5 mm Allen key.
5.
Lift up on the ring support assembly and remove
it from the grinder.
6.
Rotate push button display outward so you can
view the inside of the funnel.
7.
Remove the coffee ourlet guard by removing the
two Phillips crews using a Phillips screwdriver.
Then lift the coffee outlet guard out of the funnel.
8.
Remove outlet insert.
Note:
when completing this step, be careful
not to damage the grind control wire inside the
outlet insert.
a.
Square Outlet Insert (Robur S and Kony S):
push outlet insert toward burrs and pull
up on outlet insert lock pin. Remove outlet
insert by pulling it into the funnel and
removing it from the grinder.
b.
Round Outlet Insert (Major V): push
outlet insert toward burrs and rotate
counterclockwise a few degrees. Pull outlet
insert into funnel and remove from grinder.
9.
Vacuum out grind chamber, funnel and chute.
10.
Using the brush, brush off the burrs to remove
any built-up coffee grounds.
11.
If needed, use vacuum to remove any coffee
grounds that have been knocked loose.
12.
Wipe all mating surfaces clean using a soft cloth.
If the mating surfaces are not free of coffee
grinds and/or other debris, you will have difficulty
reassembling your grinder and may possibly
damage components.
13.
Reassemble in reverse order.
