14
EN
2) Installation on the counter
The image below shows the recommended method for drilling the hole on the counter.
Fig. 2 - Hole on the Counter
APPLIANCE CENTER
POWER CORD POSITION
FROM
∅
100 TO
∅
120 mm
FROM
∅
4 in. TO
∅
4,7 in.
WE SUGGEST TO MAKE THE
HOLE ON THE TABLE IN THIS
POSITION
DRAIN TUBE POSI
-
TION
290 mm
11,5 in.
WATER INLET HOSES
140 mm
5,5 in.
170 mm
6,7 in.
200 mm - 7,8 in.
120 mm
4,7 in.
150 mm
6 in.
60 mm
2,4 in.
3) Accessories
In order to proceed with installation, it is
necessary that the following are available:
• Pipes carrying drinking water with a
3/8”G (BSP) end connection; (3/8”
Compression for USA and Canada)
• Electrical Supply according to the
specification of the espresso machine
purchased:
• Single/Three phase 220VAC - 50/60
Hz electrical connection with ground,
protected socket and approved
interlock switch
• Single phase 200VAC - 50/60 Hz
electrical connection with ground,
protected socket and approved
interlock switch
• Three-phase, 380VAC - 50 Hz
electrical connection with neutral +
ground, near the bench on which the
appliance is installed and terminating
in a suitable protected five-pole socket
equipped with an approved interlock
switch
• Waste water drain system.
4) Water test kit
In order to enable you to check if your
water supply is within the suggested
ranges, all La Marzocco appliances will
be equipped with two quick water test kits
(see the image below) including 6 test-
strips and instruction cards.
