18
B. Mounting with adhesive tape
A. MOUNTING
WITH
SCREWS
1. Remove the mounting bracket from the remote temperature sensor.
The bracket should snap off easily.
2. Place the mounting bracket over the desired location. Through the
three screw holes of the bracket, mark the mounting surface with a
pencil.
3. Where marked, start the screw holes into the mounting surface.
4. Screw mounting bracket onto the mounting surface. Ensure that the
screws are flush with the bracket, but take care to not over-tighten.
5.
Snap the remote temperature sensor onto the mounted bracket.
B. MOUNTING
WITH ADHESIVE TAPE
1. With a nonabrasive solution, clean and dry the back of the mounting
bracket and the mounting surface to ensure a secure hold. The
mounting surface should be smooth and flat.
2. Remove the protective strip from one side of the tape. Adhere the
tape to the designated area on the back of the mounting bracket.
Remove the protective strip from the other side of the tape. Position
the remote temperature sensor in the desired location, ensuring that
the projection alarm clock can receive the signal.
M
AINTENANCE & CARE
•
Extreme
temperatures,
vibrations, and shock should be
avoided to prevent damage to the units.
•
Clean displays and units with a soft, damp cloth. Do not use
solvents or scouring agents—they may mark and damage
the displays and casings.
•
Do not submerge in water.
•
Immediately remove all low powered batteries to avoid
leakage and damage.
•
Replace with new batteries only, and of recommended size.
•
Opening the casings invalidates the warranty.
