Radio Controlled Time:
The clock automatically starts scanning the DCF time signal (
flashes on
the LCD)
The clock automatically scans the time signal at 3:00a.m. everyday to maintain
accurate timing. For failed reception, scanning stops (
on LCD disappear)
and repeats again at 4:00a.m, 5:00a.m, and 6:00a.m.
The clock manually scans the time signal by holding buttons “+”(B3) & “- “(B4).
For failed reception, scanning stops (
on LCD disappear) and repeats
again in the next 4 hours (4 times) until received. e.g. scan at 8:20 failed, it will
received again at 9:00; 10:00; 11:00; 12:00.
Stop scanning by holding “+”(B3) & “-“(B4)buttons.
*
flashes indicate now is receiving the DCF signal
turns on indicate signal received successfully
“DST” show on the LCD if it is in Daylight Saving Time Mode.
Manual Time Setting:
Press “MODE”(B2) button to change the display content:
Radio Controlled Time Time + week Alarm Time
When the Time is displayed on LCD, hold “MODE” button for 2 seconds to enter
Time setting mode.
Press or hold “+”(B3) & “-”(B4) to adjust the Hour, Minutes, Time Zone,
Language of week day, Year, Month and Day.
Press “MODE” (B2)button to confirm each setting
The TIME SETTING mode will automatically exit in 8 sec without any
adjustment.
7 languages can be selected in Day-of-week, they are: German, English, Denmark,
Dutch, French, Italian and Spanish. The languages and their selected abbreviations
for each day of the week are shown in the following table.
