15
The remote temperature/humidity sensor can be mounted in several ways:
•
With the use of screws
•
Using adhesive tape
A.
MOUNTING WITH SCREWS
1)
Remove the mounting bracket from the
remote temperature/humidity sensor.
2)
Place the mounting bracket over the
desired location.
3)
Through the two screw holes of the
bracket, mark the mounting surface with a pencil.
4)
Screw mounting bracket onto the mounting surface. Ensure that the screws are tight
against the bracket.
5)
Insert the remote temperature/humidity sensor into the bracket.
B.
MOUNTING WITH ADHESIVE TAPE
1)
With a nonabrasive solution, clean and dry the back of the mounting bracket and the
mounting surface to ensure a secure hold. The mounting surface should be smooth
and flat.
2)
Remove the protective strip from one side of the tape.
3)
Adhere the tape to the designated area on the back of the mounting bracket.
4)
Remove the protective strip from the other side of the tape.
5)
Position the remote temperature/humidity sensor in the desired location, ensuring that
the indoor weather station can receive the signal.
II.
THE INDOOR WEATHER STATION
The indoor weather station can be mounted in several ways:
•
With the use of screws
•
Using its foldout stand
A. MOUNTING WITH SCREWS
1)
Fix a screw (not included) into the desired wall, leaving
approximately 3/16 of an inch (5mm) extended from the
wall.
2)
Place the indoor weather station onto the screw using the
hanging hole on the backside.
3)
Gently pull the indoor weather station down to lock the
screw into place.
B. FOLDOUT TABLE STAND:
The foldout table stand leg is located on the backside.
1) Pull the stand out from the bottom center edge of the weather station, below the
battery compartment.
2) Once the foldout table stand is extended, place the weather station in an appropriate
location.
TROUBLESHOOTING
NOTE:
For problems not solved, please contact La Crosse Technology.
Problem:
No reception of WWVB time signal.
Solution:
1) Wait overnight for signal.
