2.
Press and release the
+
key to select the desired language.
3.
Press and release the
SET
key to confirm the language setting and enter the Manual Time
setting mode.
MANUAL TIME SETTING
In case the atomic clock is not able to detect the WWVB-signal (disturbances, transmitting
distance, etc.), the time can be manually set. The clock will then work as a normal Quartz clock.
1.
The hour digits will start flashing in the upper LCD.
2.
Select the desired hours by pressing and releasing the
+
key.
3.
Press and release the
SET
key to advance to the minutes setting.
4.
Now the minute digits will start flashing.
5.
Select the desired minutes by pressing and releasing the
+
key. If the
+
key is held, the
units will increase by 5.
6.
Press and release the
SET
key to confirm the Time setting and continue to the Year setting.
Note:
The unit will still try to receive the signal every day despite it being manually set. When it does
receive the signal, it will change the manually set time into the received time. During reception
attempts the WWVB tower icon will flash. If reception has been unsuccessful, then the WWVB
tower icon will not appear but reception will still be attempted the following hour.
WWVB time reception takes place from 12:00 am through 6:00 am each day (attempts WWVB
reception every full hour within this time frame). When the time signal is received for example at
1:00 am, the atomic clock will not attempt to receive the WWVB signal for the remaining hours
until 6:00 am. Therefore, the next signal attempt will take place between 12:00 am and 6:00 am
the next day. The other times WWVB reception takes place, are upon setup and after manual
time set exiting mode. Reception is generally not possible during daylight hours due to the
interference of the sun.
YEAR SETTING
The year can be selected sequentially from 2003 to 2029 and will then start over again (default
setting 2004). None of the digits of the year will be visible on the lower LCD display however the
year must be correct as it affects the day of the week display.
1.
The year digits will start flashing in the lower LCD.
2.
Press and release the
+
key to select the desired year.
8
