OUTDOOR TEMPERATURE TRANSMITTER:
°C OR °F TEMPERATURE SETTING
The temperature is measured and transmitted to the atomic clock every 1 minute. The atomic clock
will update the temperature display every 5 minutes.
1. The
characters
“°C”
or
“°F”
will start flashing on LCD1 (Default setting °F). By use of the
+
key
select
“°C”
for temperature display in degrees Celsius or
“°F”
for degrees Fahrenheit.
The range of the outdoor temperature transmitter may be affected by the temperature. At cold
temperatures the transmitting distance may be decreased. Please bear this in mind when positioning
the transmitter. Also the batteries may be reduced in power during periods of extreme cold
temperatures.
2.
Press and release the
SET
key to exit the setting mode and switch back to the normal display
mode.
EXIT THE MANUAL SETTING MODES
433MHz RECEPTION CHECK FOR OUTDOOR TEMPERATURE TRANSMITTER
•
To return to the normal display mode from anywhere in manual setting mode simply press the
SNZ
key anytime.
The atomic clock will receive the temperature data within 4 minutes. If the temperature data is not
being received 4 minutes after setting up (the display shows “- - -”), then please check the following
points:
•
If no keys are pressed for at least 15 seconds in setting mode, the atomic clock will
automatically switch back to normal display mode.
1.
The distance of the atomic clock or outdoor temperature transmitter should be at least 6 feet (2
meters) away from any interfering sources such as computer monitors or TV sets.
ALARM SETTING
To enter into the alarm setting mode:
2.
Avoid placing the receiver onto or in the immediate proximity of metal window frames.
1. Hold
the
ALM
key for 4 seconds. The hour digits start flashing.
3.
Using other electrical products such as headphones or speakers operating on the same signal
frequency (433MHz) may prevent correct signal transmission and reception.
2.
Press and release the + key to set the hour.
3.
Press and release the
ALM
key to set the minutes. The minute digits start flashing.
4.
Neighbors using electrical devices operating on the 433MHz signal frequency can also cause
interference.
4.
Press and release the + key to set the minutes.
5.
Press and release again the
ALM
key to exit the Alarm setting mode or wait for 15 seconds
automatic timeout.
Note:
When the 433 MHz signal is received correctly, do not re-open the battery cover of either the outdoor
temperature transmitter or atomic clock, as the batteries may spring free from the contacts and force
a false reset. Should this happen accidentally then reset all units (see
Setting up
above) otherwise
transmission problems may occur.
TO DEACTIVATE THE ALARM:
Alarm icon
(((
•
))) (ON)
The maximum transmission range is 82 feet (25 meters) from the outdoor temperature transmitter to
the atomic clock (in open space). However, this depends on the surrounding environment and
interference levels. If no reception is possible despite the observation of these factors, all system
units have to be reset (see
Setting up
).
The alarm will be automatically ON when the alarm time is set. To deactivate the alarm (OFF), press
and release once the
ALM
key in normal mode display. The alarm icon will disappear, the alarm is
now off.
CHANGING THE DISPLAY MODE (DAY, SECONDS, AND TEMPERATURES)
There are four possible display modes to view the day, seconds, and temperatures.
SNOOZE SETTING
The
month&date/weekday/indoor temperature/outdoor temperature is the default.
The snooze can only be activated during alarm time for a snooze duration of 10 minutes by pressing
the SNZ key on the back of the clock
To change the display:
