16
NOTE: You must insert the batteries into the third sensor within 45
seconds of reception of the second sensor.
IMPORTANT
: Transmission problems will arise if the setting for multiple sensors
is not followed as described above. Should transmission problems occur, it is
necessary to remove the batteries from all units and start again the set-up from
step 1.
Viewing and Operating with Multiple Remote Sensors
a.
To view the temperature of a different remote sensor press and
release either of the
“SNOOZE/CH”
buttons. A shift from
one “boxed” number to the next should be observed in the
OUTDOOR LCD.
b.
The minimum and maximum temperature of the additional
remote sensor can be displayed by pressing the
“OUT/+”
button.
c.
To reset the minimum and maximum temperature readings
press and hold the
“SET”
button for 3 seconds and that
temperature/humidity record for that remote sensor will be
reset only.
Each remote sensor will have its own minimum and maximum values
stored.
E.
Comfort Indicator for Indoor Temperature and Humidity
1.
The comfort level indicator appears inbetween the indoor
tempearture and humidity.
2.
The indicator will display a “happy-face” when the temperature is
between 68
°
F and 79
°
F (20
°
C and 25.9
°
C), and the humidity is
between 45% and 64%.
3.
A “sad-face” will be displayed when the temperature and humidity
are outside the mentioned ranges.
F.
Weather Forecast Icon and Pressure Trend Indicators
The weather forecasting feature is estimated to be 75% accurate, and is
based solely upon the change of air pressure over time. The WS-
8035U-IT averages past air-pressure readings to provide an accurate
forecast—creating a necessity to disregard all weather forecasting for
12-24 hours after the unit has been set-up, reset, or moved from one
altitude to another (i.e. from one floor of a building to another floor).
In areas where the weather is not affected by the change of air pressure,
this feature will be less accurate.