2) Move the Atomic Clock closer to the transmitter or place the transmitter
closer to the Atomic Clock. Make sure the clock is at a receivable range
from the transmitter.
3) Move the units to another location. Interferences from other electrical
devices operating on the same signal frequency (433MHz) may prevent
correct signal transmission and reception.
Problem:
"OFL“ appears in the outdoor temperature section of the LCD.
Solution:
1) Wait until the current surrounding temperature cools down or increases.
Current temperature is outside of the measuring range of the transmitter.
The outdoor temperature will be displayed again once the current
surrounding temperature is within the range of the transmitter.
CARE AND MAINTENANCE
:
•
Avoid placing the units in areas prone to vibration and shock as these may cause damage.
•
Avoid areas where the units can be exposed to sudden changes in temperature, i.e. direct
sunlight, extreme cold and wet/moist conditions as these will lead to rapid changes which reduces
the accuracy of readings.
•
When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents or scouring
agents.
•
Do not submerge the units into water.
•
Immediately remove all low powered batteries to avoid leakage and damage. Replace only with
new batteries of the recommended size.
•
Do not make any repairs to the units. Please return it to the original point of purchase. Opening
and tampering with the units may invalidate the warranty.
SPECIFICATIONS:
Temperature measuring range
Indoor: +32ºF to +122ºF with 0.2ºF resolution
0ºC to +50ºC with 0.1ºC resolution
("OFL" displayed if outside this range)
Outdoor
: -21.8ºF to +140ºF with 0.2ºF resolution
-29.9ºC to +59.9ºC with 0.1ºC resolution
("OFL“ displayed if outside this range)
Temperature checking interval
Indoor: every 10 seconds
Outdoor: every 5 minutes
Transmission distance: maximum 82 feet (25 meters) in open field, depending upon surrounding
structures, mounting location and possible interfering sources
Power source (Alkaline batteries recommended)
Atomic Clock : 2 x AA, 1.5V batteries
Transmitter: 2 x AA, 1.5V batteries
Battery life: about 12 months
Dimensions (L x W x H)
Atomic Clock : 11.41“ x 0.98“ x 7.48“ / 290 x25 x190mm
Transmitter: 1.57“ x 0.9“ x 5.04“ / 40 x 23 x 128 mm
LIABILITY DISCLAIMER:
•
The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any
consequences that occur should an inaccurate reading take place.
•
This product is only designed for use in the home or office.
•
This product is not to be used for medical purposes or for public information.
•
The specifications of this product may change without prior notice.
•
This product is not a toy. Keep out of the reach of children.
•
No part of this manual may be reproduced without written authorization of the manufacturer.
BATTERIES CHANGE:
For best performance, batteries should be replaced at least once a year to maintain the best running
accuracy. Ensure that the batteries used are new and the correct size.
Please help in the preservation of the environment and return used batteries to an
authorized depot.
