9
(c)
Press the “
ALARM”
button to confirm the hour, and to set the alarm
minutes.
(d)
The alarm minutes flash, press the “+” button to set the alarm minutes.
(e)
Press the “
ALARM”
button to confirm and to exit the alarm setting
mode.
Note: The alarm will be automatically set to sound when exiting the
alarm-setting mode (indicated by the alarm “sound” icon to the right
of the time).
2)
ACTIVATING/DEACTIVATING THE ALARM
(a)
The alarm will be automatically set to sound when exiting the alarm-
setting mode (indicated by the alarm “sound” icon to the right of the
time).
(b)
Press the “
ALARM”
button to activate and deactivate the alarm. The
alarm “sound” icon to the right of the time will appear or disappear,
and the alarm time will be displayed briefly before returning to the
normal display mode.
3)
ACTIVATING THE SNOOZE FUNCTION
(a)
While the alarm is sounding, press the “
SNOOZE”
button to activate
the snooze function. The alarm “sound” icon and “SNOOZE” icon (to
the right of the time) will flash. The duration of the snooze function is
10 minutes, then the alarm will resume.
4)
SUSPENDING ALARM
(a)
While the alarm is sounding or the SNOOZE is active, press the
“ALARM”
button to suspend the alarm until the next day.
C)
INDOOR TEMPERATURE
The Indoor Temperature appears on the right side of the Date LCD. The
temperature is checked every 10 seconds, and updated whenever there is a
change.
D)
REMOTE TEMPERATURE
The remote temperature will be shown on the right side of the lower LCD
screen. The Weather Temperature Station receives the outdoor temperature (
F
or
C) from the Remote Temperature Transmitter, and the temperature appears
in the OUTDOOR LCD. The Remote Temperature Transmitter transmits a new
temperature to the Weather Temperature Station 3 times every 10 minutes.
10
MOUNTING
There are two possible ways to mount the Temperature Clock: 1) use of the foldout table
stands, or 2) wall mounting.
E)
FOLDOUT TABLE STANDS
The Foldout table stand legs are located on the
backside, at the lower corners, and on both sides of
the battery cover. The hinges are towards the edges
of the Temperature Clock, and the ends (with no
hinge) need to be folded out towards the edge. Once
the Foldout table stands are extended, place the
Temperature Clock in an appropriate location.
F)
WALL MOUNTING
1)
Using a straightedge, horizontally space at 3-
15/16 of an inch (100.58mm) three screw
positions on a wall.
2)
Install three mounting screws (not included) into
a wall within transmission range—leaving
approximately 3/16 of an inch (5mm) extended
from the wall.
3)
Place the Temperature Clock onto the screws, using the hanging holes on
the backside. Gently pull the Temperature Clock down to lock the screws
into place.
IV)
THE REMOTE TEMPERATURE TRANSMITTER
A)
The Remote Temperature Transmitter can be mounted in two ways: 1) with the
use of screws, or 2) using the adhesive tape.
Hanging Holes
Foldout Table Stands
Function Buttons
