La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 3
Compatible Remote sensors
The TX141TH-BCH remote sensor comes packaged with this weather station.
The TX141TH-ACH (433MHz) remote sensor is compatible with this weather
station.
Quick Connect
Explanation: Use the quick connect for a weather station and remote sensor that
have been working but lost connection due to interference or low batteries. This is
not the same as a thorough factory reset.
1.
Bring the remote sensor and weather station together inside, and place the
units 5-10 feet apart with nothing between them.
2.
Hold the INFO button for 5 seconds. The remote temperature area will flash.
3.
Remove battery cover from the remote sensor and press and release the TX
button to send the signal.
4.
Wait for 2 minutes for the remote temperature to appear on the weather
station.
If the above procedure does not work, please try the factory
reset.
Remote Temperature Signal Strength
Explanation: The weather station will search for the remote temperature/humidity
remote sensor for 3 minutes after batteries are installed or when the INFO button is
held for 3 seconds.
The antenna symbol will flash during reception.
The temperature display will be dashes “---“.
If synchronization fails once, the antenna will lose one bar.
If synchronization fails twice, the antenna will lose two bars.
If RF (radio frequency) reception fails five times, the antenna symbol will show
without bars.
The antenna will show full display with successful RF (radio frequency)
reception.
Dashes show for Remote Temperature
Explanation: Dashes mean the connection is lost between the weather station and
the remote sensor.
often resolve the connection.
can cause loss of connection between the remote sensor
and the weather station.
Turn the weather station 90 degrees towards the remote sensor to provide
better reception. This allows more antenna surface to face the remote sensor
signal.
or
