La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 10
Look for heat sources such as sunlight, door or window frames or reflected heat or cold
near the weather station.
Check
and AC power cord
.
Set Time Alarm
In normal mode, hold the ALARM button for three seconds to enter alarm set mode.
1.
HOUR: The
Hour
will flash, use the
▲
or
▼
buttons to set the hour, and press ALARM
button to confirm and switch to minutes.
2.
MINUTES: The
Minutes
will flash, use the
▲
or
▼
buttons to set the minutes, and press
ALARM button to confirm and exit.
Note:
When no buttons are pressed for ten seconds, the weather station will save the last
change and default back to normal mode
Activate/Deactivate time alarm
In normal mode, press and release the ALARM button once to show alarm time.
Press and release the ALARM button repeatedly to turn ON/OFF alarm.
The alarm icon appears when alarm is active.
Note:
The alarm will ring for 2 minutes then turn off if no buttons are pressed.
Snooze Alarm
When the alarm sounds, press the HI/LOW/OFF
button to snooze the alarm for 10
minutes.
The snooze option can repeat three times.
The alarm icon will flash while the snooze feature is active.
Note:
while the alarm sounds press any button
except
the ALARM button to turn the
alarm off.
No WWVB Tower Icon
The forecast station has not received a WWVB time signal in the past 24-hours.
Position
the forecast station for better reception.
Be sure you have good batteries in the forecast station.
Hold the + and
– buttons together to send the forecast station on a signal search at night.
Allow up to 5 nights to receive the time signal.
Time is off by hours
Check to see if the
Tower icon appears on the forecast station. If not, the forecast station has
not received a WWVB time signal in the past 24-hours.
Reposition the forecast station with the front or back facing Colorado.
Check that the Time Zone selected correctly reflects your location. Adjust the time zone in the
Check that the DST indicator is correct for your location (most areas observe DST so this should be
ON). Adjust the DST indicator in the
Manually Set Time/Date: Program Menu
The TIME SET button will move through the program menu. To change a value use the
ARROW buttons.
