Page
34
LA CORNUE
Installation Guide Centenaire
08NOTINSTAL100/USA-6
US
A & C
AN
AD
A
Electrical - Gas supply
I
NSTALLATION
Voltage
: 240 V a.c.,
single-phase, 3 wire system
Safety
:
The range, when instal led must be electrical ly grounded in accordance with
local codes, or in the absence of local codes, with the latest edition of
the National Electrical Code, ANSI / NFPA 70 in the USA and the Canadian
Electrical Code, CSA C22.2, in Canada as applicable.
Power
:
Check the power rating at your electric meter (maximal load) to ensure that it is suitable
for your model, taking into account all other electrical appliances installed on the same
circuit.
The tables in pages 14, 17, 20, 24, 28 and 32 show the necessary power and amp ratings for
each La Cornue model.
The power of the "La Cornue" stoves,
does not al low for a simple plug and socket connection
; the
electrical connection must be made by means of an
adequate flexible cord,
built-in
junction box,
with terminal blocks
; the box is located about
12" (300 mm) from the floor
, on the wall behind the
stove, on the right.
Use sealing compound on all pipe joints. Compound used must be resistant to the action of LP Gases.
The gas supply line to the appliance must be at least the same size as the gas inlet. An
easily accessible
manual shutoff valve
must be installed, keeping in mind the fact that on the appliance, the gas inlet is
located:
- On the left-hand side of the appliance, approximately 2
1/2
" (60 mm) from the edge.
- 24" (620 mm) above the floor
(for the ranges)
.
NOTE :
Make sure that the supply line is clear of burrs and metal particles in order to avoid damage to the
gas controls once the gas is turned on. The pipe connections can then be made
When your "La Cornue" appliance is installed between kitchen cabinets, the manual shutoff valve should
be accessible. We recommend it be located at the rear of an adjacent cabinet.
According to gas regulations, any opening in the wall or on the floor for gas supply of the appliance must
be properly sealed as well as any circulation of air between the gas supply room and the kitchen.
When all the work has been carried out on your gas supply network, ensure that no metallic burr can
enter the supply tube of the stove and block the burners. Then make sure that all gas connections are pro-
perly sealed. Refer to page 43 for initial test of the unit prior to turning the gas on. Refer to "Important
Safety Information" section, on pages 1 - 8.
In order to ensure that the range is perfectly horizontal, especially in a kitchen with old paving or floo-
ring, we recommend that you install the stove on a wooden or cement base, the height of which will bring
the hot top to a level in accordance with its environment or your requirements.
We recommend a base of the exact size of the stove base.
4. I
NSTALLATION
3. G
AS SUPPLY
2. E
LECTRICAL SUPPLY
Summary of Contents for Grand Palais 180
Page 2: ......
