INSTALLATION GUIDE FOR
“C
HÂTEAU
” RANGE
- G4
08NOTINSTALG4/EN - 3
83
Once the appliance has been adapted to a different type of gas or to a pressure other than those for
which it was previously set, the new settings will have to be indicated in place of the previous
settings, and a new gas information label will be supplied with the new injectors.
The appliance is preset in the factory. The adjustment screws and gas connectors are sealed.
Any sealing will have to be replaced.
5
ADJUSTING THE LOW SETTINGS
Only the low settings for the gas hob burners, the hotplate and the lava rock grill can be adjusted with the
following procedure:
1.
Ignite the burner to be adjusted, and then turn the control knob to the "low" position.
2.
Dismantle the control knobs by loosening the screw which holds in each one in place with the
spanner provided.
3.
Turn the split screw on the body of the gas tap towards
the left to increase the flow or towards the right to reduce
it.
For Butane and Propane gas, turn the knob fully to the
right.
Make sure that the resulting flame, at the lowest setting,
is sufficiently strong to heat the thermocouple.
4.
Refit the knob to turn the burner off, ensuring that you
leave a sufficient gap between the knobs and the tap
cover (the knob, when held down, should not come into
contact with the tap cover).
