L-Card ADC Series, User Manual, Page: 11 / 69

Chapter 2. Installation and configuration.
2.1. E-502 configuration "by default".
E-502 comes with presets "by default" corresponding to the table below.
Configuration E-502-P-EU-D
E-502-P-EU-D-I
E-502-X-U-D E-502-X-U-X
E-502-X-EU-X
Setting the resolution of the
high and low byte of DO
digital outputs on the
Analog connector
Programmed
control
(no jumper on
fig. 2-1 on the
left)
Programmed control
(no jumper on fig.
2-1
on the left)
Programmed control
(no jumper on fig.
2-1
on the left)
Output setting
DAC1 / +15V / AGND / NC
on
Analog connector
DAC1
(See fig. 2-1 )
DAC1
(See fig. 2-1 )
NC
(See fig. 2-1 )
Output setting
DAC2 / -15V / GNDD / NC
on
Analog connector
DAC2
(See fig. 2-1 )
DAC2
(See fig. 2-1 )
NC
(See fig. 2-1 )
"L-Card" installs this configuration using jumpers on the board ( fig. 2-1) – inside the pack. See
configuration explanation in subsection
2.2.1
,
2.2.2.
Note: How to programmatically resolve the Ethernet interface, explained in p.
2.8
.