Figure 3.2 Component Identification
Installation and Assembly Instructions
ASSEMBLY
WARNING
Fire or explosion hazard!
Do not operate heater without support frame fully
assembled to tank.
Front Handle
Rear Handle
Axle
Wheel Support Frame
TOOLS REQUIRED
CP045CK/CP075CK
CP125DK/CP175DK/CP210DK
- Medium Phillips screwdriver.
- M5 open, or adjustable wrench.
1. Slide threaded axle through the rear section of the wheel support frame.
NOTE When installing wheels, tube valve should face out from support frame (Figure 5).
2. Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle.
3. Attach one cap nut on to each side of the threaded axle and tighten well.
4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fuel
tank flange. Insert screws through handles (front and rear), fuel tank flange, and wheel support frame as shown in
Figure 5 and attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.
7. Insert screws through cord wrap, handles as shown in Figure 5 and attach nut finger tight after each screw is inserted.
8. After all screws are inserted, tighten nuts firmly.
USE CAUTION WHEN INFLATING TIRES:
- Do NOT over inflate tire. Maximum air pressure is 36 PSI.
- Over inflation may lead to serious injury
- NEVER fill tires using an air compressor. A manual pump is recommended
Wheel Support Frame
Wheels
Front-Handle
Rear-Handle
Axle
Yes
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
No
No
Yes
Cord Wrap
H
Handle
ardware Kit
Model
CP045CK/CP075CK CP125DK
CP175DK
CP210DK
CP175DK CP210DK
Cap Nut S
Cap Nuts L
Flange Screws
Nuts
Bushings
Wheels
CP125DK /
/
Cord Wraps
Screws
Figure – Component Identification
Handle
Hardware Kit
Cord Wraps
CCPP004455CKK // CCPP007755CKK M
Mooddeellss
Handle
FFiigguurree 44
– Handle and Cord Wrap Installation CP045CK and CP075CK
Front Guard
Screw
Side Cover
Supporter
Cord Wrap
Wedged
Portion
Slit Hole
Screw
3.1
- Medium Phillips screwdriver.
1. Lift front guard for arrow direction and make sure that guard’s wedged portion fits into the slit hole on the upper housing.
2. Align the holes in upper housing with two mounting holes on the handle as shown in Figure 4.
3. Secure handle with screws provided.
4. Insert cord wrap into the rectangle holes on the supporter and align the hole on the cord wrap with the mounting hole on the side
covers shown in Figure 4.
5. Secure cord wrap with screws provided.
9