1.
Connect the hardware components and regulator at
the heater gas inlet as shown in Fig. 4. Ensure flow
arrow on regulator body is in direction of gas flow.
Tighten all securely.
2.
Connect swivel end of hose to hose adapter and
tighten securely. Connect opposite end of hose to
natural gas supply.
FIG. 4
NIPPLE, 3/8
BUSHING, 1/2 x 3/8
NIPPLE, 1/2
GAS SHUT OFF
HOSE ADAPTER
1/2 NPT x 1/2 NPS
HOSE, SWIVEL END
TO GAS SUPPLY
■
Only use the L.B. White regulator supplied with the
heater.
■
The heater must be regulated at all times for proper
operation.
■
The regulator must be installed so its vent is directed
downward.
■
Leak check all regulator connections whenever the
regulator is connected to the gas supply.
1.
Always use approved pipe thread compound suitable
for use with L.P. gas or natural gas on the threaded
connections.
2.
At the inlet of the regulator is a male nut and stem
called a POL assembly. Remove the cap from the POL
Insert POL stem into the valve on the cylinder. Thread
the nut counterclockwise into the tank valve. Ensure
regulator vent is pointed down. Tighten the nut
securely with a wrench. See Fig. 5.
3.
Slowly open the cylinder valve. This will prevent lock-
up of the excess flow valve built within POL stem.
4.
When storing or transporting the heater, ensure the
POL fitting is protected from damage and water entry.
FIG. 5
1.
Connect rigid end of hose to regulator and tighten
securely.
FIG. 2
2.
Install hose adapter to gas inlet of heater. Connect
end of hose with nut to hose adapter. Tighten both
securely. See Fig 3.
FIG. 3
HOSE AND REGULATOR ASSEMBLY
CONNECTING PROPANE REGULATOR TO PROPANE GAS CYLINDER
VENT
POL NUT
AND STEM
9
Propane Gas
Natural Gas
REGULATOR
Summary of Contents for CP155
Page 2: ......
