L.B. White AD060, Owner'S Manual And Instructions

Page: 11 / 80

Guardian Brood Heaters
Owner’s Manual • Guardian
11
(Appearance of the outlet on brood
heater may vary from model to model.)
1. Outlet to provide direction to the heated air as it
exits the brood heater. Installation options include
installing the diverters in such a way as to broadly
NOTCHES IN MOUNTING TABS distribute the air
LQWZRGHJUHHSDWKVRUWRIRFXVWKHDLUÀRZLQ
one 45 degree direction. See Fig. 1.
2. The air diverters may require hand forming prior
to installation. Make 90 degree bends utilizing the
performations provided. The diverter should then
have the shape shown in Fig. 1.
3. The air diverter’s tabs on each half will pop
into the blower outlet between the inside of the
case assembly and the blower housing outlet.
If the notched tabs do not pop into the blower
outlet, loosen (do not remove) the blower outlet
screws. Doing this provides a gap into which you
can insert the tabs. Retighten the screws after
installation.
FIG. 1
TABS
DIVERTER
HALVES
OUTLET
SCREWS
FORMED
OUTLET GUARD
NOTCHES IN MOUNTING TABS
Alternatve Air DIverter Installations
Air Diverter Installation
Instructions
(Must be ordered separately)
1. Assemble according to the illustration and tighten all
eyebolts securely. See Fig. 2.
FIG. 2
EYEBOLT
NUT
FLAT WASHER
CAGE NUT
CHAIN
CASE TOP
2. Be sure the brood heater is securely fastened and
is hanging level. (Check crosswise and lengthwise
using a level).
3. See Fig. 3 for typical indoor installation. In any
DQLPDOFRQ¿QHPHQWEXLOGLQJFRQVLGHUDWLRQPXVWEH
given to making sure the brood heater is located
away from the livestock so that livestock can-
not knock the brood heater, tear it loose from its
mounting, or damage the brood heater or its gas
supply line in any way. Make sure you observe and
obey minimum clearance distances to combustible
PDWHULDOVDVVWDWHGLQWKHVSHFL¿FDWLRQVHFWLRQRIWKLV
owner’s manual and on the brood heater itself.
FIG. 3
NOTE: REGULATORS SHOULD ALWAYS BE MOUNTED OUTDOORS. IF
CIRCUMSTANCES FORCE INSTALLING THE REGULATOR INDOORS,
THE REGULATOR'S VENT MUST BE VENTED OUTDOORS USING VENT
LINE NO SMALLER THAN VENT OPENING.
VENT OF REGULATOR MUST
POINT DOWN AND REGULATOR
MUST BE VENTED OUTDOORS
MANUAL SHUT-OFF VALVE
CAN BE INSTALLED BEFORE
THE REGULATOR, UNDER
THE EAVE OF THE BUILDING,
OR AFTER THE REGULATOR
INSIDE THE BUILDING.
OPTIONAL INDOOR
REGULATOR
MOUNTING LOCATION
GAS HOSE
THERMOSTAT
CORD
YOKE
BROOD
HEATER
THERMOSTAT
0.3 m
BLACK PIPE
THROUGH WALL
VENT LINE
WALL OUTLET
POWER CORD
SEDIMENT
TRAP
WALL
CHAIN OR CABLE
0.3 m