L-Acoustics WST K2, Rigging Manual

Page: 15 / 52

K2_RM_EN_0.5
w w w . l - a c o u s t i c s . c o m 1 5 / 52
4.2 Flying
Final check
After the setup, always verify no yellow labels are visible on the front and on both sides of the array.
At least one motor for each K2-BAR
When using two K2-BAR, do not implement a bridle between the bars.
Before setup, choose a flying option
Refer to SOUNDVISION modeling and to 3.3 Elements for flying (p. 2).
K2 enclosures under K2-BUMP

Prepare all the blocks of 4 K2 necessary to build the array.
If a block is not already built , refer to PROCEDURE A .

Preset the inter-enclosures angles.
Refer to PROCEDURE B .

Place an open a K2-BUMPFLIGHT under the motor.
 If necessary , attach one or two K2-BAR to the K2-BUMP.
Refer to PROCEDURE D .
 If necessary , stack one or two LA-RAK on the K2-BUMP.
Refer to PROCEDURE I .
Refer to APPENDIX A: when stacking only one LA-RAK.
 Attach the shackles.
Refer to SOUNDVISION for the number and position of the shackles.
 Lift the assembly so you can position a block of four K2 under it.
 Attach the block of four K2 to the K2-BUMP
Refer to PROCEDURE E .
Verify that the rear rigging arms are secured by pins and that no yellow
label is visible on the front.

Lift the assembly so you can position a block of four K2 under it.
Verify that no yellow label is visible on both sides of the array.
 Attach the block of four K2 enclosures to the bottom of the array.
Refer to PROCEDURE F .
Verify that the rigging arms at the back are secured by pins and that no
yellow label is visible on the front.

Repeat the last two steps until the array is complete.

Raise the array to its final trim height.
 Adjust site and azimuth angles.