Operation
Other operations
The following operations can only be done from LA Network Manager:
• Preset management (loading, storing, deleting).
• Preset parameters (gain, delay, polarity, input selection).
• Group parameters (names, gains, delays, contour EQs).
• Input settings (input modes, fallback modes, fallback gain).
• Output modes.
• Mute/Unmute.
• GPIO conguration.
• Monitoring and status (temperature, mains voltage, rmware and preset library versions, settings protection).
• IP settings (for subnet settings, refer to
Setting the IP via USB
(p.27)).
• Spanning tree setting (RSTP) and network modes.
• Standby mode and reboot.
Refer to the
LA Network Manager
Help for more information.
Setting the IP via USB
If the IP address of LA2Xi needs to be set on a different subnet, then proceed as follows.
Procedure
1.
Identify the IP address and the subnet mask of the network card of the computer on which LA Network Manager will
be run.
2.
Open the application with LA Network Manager.
Click
>
Utilities
>
USB Terminal
.
3.
Click
Scan
to retrieve the list of serial ports on the computer. Expand the list to visualize the ports detected.
4.
Connect LA2Xi to the computer with a USB cable.
5.
Click
Scan
, and select the COM port that appeared in the list.
6.
Click
Refresh
to retrieve the LA2Xi information.
7.
Enter the same
Netmask
as that of the network card that will be used to connect to the LA2Xi.
8.
Assign a unique IP address to each LA2Xi on the corresponding subnet.
9.
Click
Apply
.
LA2Xi owner's manual (EN) version 1.0
27
