SB18_RM_EN_1-0
w w w . l - a c o u s t i c s . c o m
17
17
17
17
APPENDIX
APPENDIX
APPENDIX
APPENDIX C
C
C
C:::: INSTALLING THE LAP-TEQ INCLINOMETER
A laser support plate has been integrated to the M-BUMP and the KARA-MINIBU for the optional installation of the
TEQSAS
®
LAP-TEQ inclinometer. The LAP-TEQ is a remote control device which is part of the
L-ACOUSTICS
®
TECH TOOLCASE
.
LAP-TEQ inclinometer installed on the M-BUMP (left) or the KARA-MINIBU (right)
Required material
Electric screwdriver with torque selector, T20 Torx
®
bit, 7 mm hex key
Put the M-BUMP or KARA-MINIBU with identification plate right-side up.
Undo the four Torx
®
bolts on the laser support plate (T20 bit, 7 mm hex key).
Place the LAP-TEQ on the laser support plate with laser lens towards the front laser slit, verifying nothing obstructs
the slit opening.
Drive the four Torx
®
bolts into the holes of the inclinometer and the plate (T20 bit, 7 mm hex key, 3 N.m/27 in.lb
f
).
APPENDIX D:
APPENDIX D:
APPENDIX D:
APPENDIX D: SAFETY PIN MECHANISM ON SHACKLES
Calibrating the LAP-TEQ
Refer to the manufacturer instructions in the
L-ACOUSTICS
®
TECH TOOLCASE.
In addition to the
handheld inclinometer available in the TOOLCASE, an XLR3 cable is needed.
Securing the shackle
ALWAYS put the safety pin in locked position to secure an assembly
Unlock
Lock