SB18_RM_EN_1-0
w w w . l - a c o u s t i c s . c o m
13
13
13
13
D.
Preparing the KARA-MINIBU flying structure
Required material
Electric screwdriver with torque selector, 6 mm hex bit, 13 mm hex key
Attach two KARA-MINIBUEX to the KARA-MINIBU.
a.
Place a KARA-MINIBU at the rigging location with the identification plate right-side up;
b.
On each side, install one KARA-MINIBUEX, with feet up, by inserting one of its stud into a KARA-MINIBU slit;
c.
Secure the assembly by driving 3 bolts on each side (6 mm hex bit, 13 mm hex key, 7 N.m/63 in.lb
f
).
Orientation of the KARA-MINIBU frame
The KARA-MINIBU frame is symmetrical so that the installation as a front or rear extension can be
achieved wherever the KARA-MINIBUEX are installed. However, it is recommended at this step to
anticipate the front or rear extension so as to keep the laser plate at the front of the array.
Attach the shackle(s) to the KARA-MINIBU, in the hole(s) corresponding to the chosen flying option and providing
the desired site angle (see modeling in SOUNDVISION and APPENDIX
B
).
If needed, install a laser device on the laser plate (see APPENDIX
C
).
PROCEDURE D
: Preparing the KARA-MINIBU flying structure
b
A MINIBUEX stud being inserted
into a KARA-MINIBU stud
c
The MINIBUEX/KARA-MINIBU assembly being secured
on one side with 3 hex screws (M8 x 25 mm) and 3 nuts
A Ø12mm bow shackle
being attached
A CLAMP250
being attached
END
The KARA-MINIBU flying structure ready
(Option 4, see APPENDIX
B
)
