L-3 Communications Office STE, User Manual

Page: 110 / 312

TPA Functions STE User’s Manual
4-18 Rel. 2.6
Press: Result:
SELECT Advances display to the ZEROIZE TERMINAL menu (Paragraph 6-7 )
SCROLL Returns display to the TERMINAL MANAGEMENT menu
BACK Exits menu function – clears display
4-5. TERMINAL PRIVILEGES, ASSOCIATION, AND SOFTWARE UPDATE
MANAGEMENT – TPA Settings
All parameter settings discussed in this and subordinate paragraphs are TPA exclusive. However, all
users may view the setting as discussed in Paragraph
5-2 . Foldout 4 provides the hierarchy arrangement
for the TPA functions.
The default settings for the terminal privileges are shown in
Table 4-1 .
Table 4-1. Terminal Privilege Defaults
Setting Default
Terminal Privileges
Terminal Configuration Control
Initial Secure Mode Auto secure
Change TPA Password None
Remote Control Disabled
Remote Authentication Enabled
Remote Nonsecure Voice Disabled
Card Privileges Disabled
Secure Access Control System
Access Control List Empty
Secure Applications
Secure Data Applications Enabled
Secure Data ACL Disabled
Minimum Security Level None
Maximum Security Level None
Secure Voice Application Enabled
Secure Voice ACL Disabled
Minimum Security Level None
Maximum Security Level None
Speakerphone Control
Non-secure Speakerphone Disabled
Secure Speakerphone Disabled
Remove/Create CC Association
Remove Association By Number
Create a New Association
Software Version (Load New Software)
To access the Terminal Privileges, Association, and Software Update Management menu perform the
following:
1. Insert the TPA Card into the CRYPTO CARD SLOT , at the front of the STE, and press MENU .
At the TERMINAL MANAGEMENT menu press SELECT then press SCROLL .
2. The TERMINAL PRIVILEGES, ASSOCIATION AND SOFTWARE UPDATE MANAGEMENT
menu ( Figure 4-29 ) is presented.