L-3 Communications Office STE, User Manual

Page: 180 / 312

Crypto Card Management STE User’s Manual
6-24 Rel. 2.6
(Paragraph 6-6 )
This is the last feature in the Crypto Card Management function. Press MENU to clear the display.
6-7. ZEROIZE TERMINAL
The ZEROIZE TERMINAL menu ( Foldout 1 ) may be accessed by all authorized users.
CAUTION
Do not use the ZEROIZE function as a means of trying to clear problems in the
STE terminal. Follow the recommended maintenance procedures.
When the ZEROIZE TERMINAL function is initiated, all configuration settings are reset to, the STE’s
default values as shown in
Table 4-1 and Table 5-1 . In addition, terminal user associations including the
current TPA are removed. However, if the Initial Secure Mode had been set to “Secure-Only” the setting
is retained. Audit Information is also retained after zeroizing the STE.
To zeroize the terminal, press
MENU and then press SCROLL twice to display the ZEROIZE TERMINAL
menu ( Figure 6-61 ).
Figure 6-61. Zeroize Terminal Menu
Press: Result:
SELECT Advances display to ZEROIZE TERMINAL (CONFIRM) menu ( Figure 6-62 )
SCROLL Advances display to TERMINAL MANAGEMENT menu
BACK Exits MAIN Menu function – clears display
Press SELECT .
When SELECT was pressed, the confirmation menu ( Figure 6-62 ) is displayed.
Figure 6-62. Zeroize Confirm Menu
Press: Result:
CONFIRM Initiates the zeroizing process
ABORT Returns display to TERMINAL MANAGEMENT
Press CONFIRM .
This process takes approximately one minute. When you are notified that the process is complete, press
CONTINUE .
ZEROIZE TERMINAL
SELECT SCROLL BACK
ZEROIZE TERMINAL
ABORT CONFIRM