KZ RV SPORTSMEN, Owner'S Manual, Page: 49 / 101

42
SCHWINTEC WALL SLIDE
System is composed of four tracks placed on the outer sidewall of
slide, two at the bottom and two near roof line. On each side an
extrusion is attached to sidewall with a motor inside at the top of
extrusion, accessible only from inside. A gear mounted to the motor
will run on the upper track to move slide in or out. Wire harness is
along side of extrusion.
Power is supplied by 12 volt DC, convertor and/or auxiliary battery
through a module board, located under the slide or near the slide in
a cabinet.
Operation error codes are listed and found in the manual supplied
by manufacturer of equipment for circuit board and other
components.
It is very important to keep tracks clean from dirt and debris.
Don’t forget, each side has it’s own motor . Should slide move at an
angle, one motor may be disconnected or failed to move.
MANUAL OVERRIDE
A. MANUAL OVER RIDE, ELECTRIC
1. Locate the circuit board.
2 . Press the “ mode button six times quickly, press a 7th time and
hold for approximately 5 seconds. The red and green LED
lights will begin to flash, confirming the override mode.
3. Release mode button.
4 . Back inside coach, use the normal control switch to retract the
room.
B. MANUALLY PUSH ROOM IN OR OUT
1. Unplug both motors from circuit board. This releases the motor
brake.
2. Push or pull slide room in as desired. Larger rooms may
require several persons to move slide Keep both sides even.
3. When room is completely in, plug both motors back into the
circuit board to apply brake for road travel.
4. Room must be travel locked during travel.
PDF created with pdfFactory trial version www.pdffactory.com