Kyocera TJEP 8/10-2, Safety And Operation Instructions

Page: 16 / 132

16
Problem Possible cause Solutions
The pressure is low or there is
not enough air.
There is a leak at one of the
fittings.
Check the fittings with soapy water. Tighten or reseal leaking fittings
(apply plumber s tape on threads). Do not over tighten.
The tank drain valve is open. Close the drain valve.
The air intake is restricted. Clean or replace the air filter elements.
Prolonged excessive use
of air.
Decrease the amount of air used.
There is a hole in the air
hose.
Check the air hose and replace it if necessary.
The tank leaks. Replace the tank immediately. Do not attempt to repair it.
The valve is leaking. Check for worn parts and replace them if necessary.
There is moisture in the
discharge air.
There is condensation in the
air tank caused by a high
level of atmospheric humidity
or because the compressor
has not been running long
enough.
Drain the air tank. Drain the air tank more often in humid weather
and use an air-line filter.
The compressor overheats.
The ventilation is inadequate. Relocate the compressor to an area with cool, dry and well-circu-
lated air.
Cooling surfaces are dirty. Clean all cooling surfaces on the pump and the motor thoroughly.
The valve is leaking. Replace worn parts and reassemble using new plumber’s tape.
For failure other than above situations, please stop using the compressor and contact your local TJEP dealer for service.